Amano MRX-35 Manuale delle Operazioni Scaricare il pdf (Pagina 30)

3-10 MRX-35

Time Rounding

Time Rounding is used to simplify the calculation of accumulated hours.

When an IN/OUT punch equals or is greater then the Rounding Point,

that time is rounded up to the next Rounding Unit. When an IN/OUT

punch is less then the Rounding Point, it is rounded down to the previous

Rounding Unit.

If you are using Revision Zones, the Rounding Unit and Rounding Point

will be ignored and the settings of the Revision Zones will be applied to

the punch.

The Rounding Unit is set to a default of (15) and the Rounding Point

default is set to (8). To set the Rounding Unit and Point, perform the

following:

1. If you have not already done so, insert

MRX Basic Programming Card #2 Side

and advance it to the Rounding Unit

position by pressing the Next button

twice.

2. Make a selection by pressing the buttons

indicated by the programming card. The

choices are: 1 Minute, 6 Minutes, 15

Minutes (Default), or Adjustable (1

through 60 minutes). If you are using the

Adjustable setting, press the button

indicated until the desired value appears

in the display.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 76 77

Nessun commento

Amano MRX-35 Manuale delle Operazioni Pagina 30